Snowflake Card

Cut two 3 ½”x6 ½” pieces of the snowflake Foiled Acetate. Use the 12 Oval & Scalloped Dies to cut a large scalloped oval from one long side of each piece. Score the straight edge on each piece leaving 1/4" for attaching to the back of card base. With the Knife make a slit at the center of the folded acetate oval for the ribbon closure later. 

Cut 5"x6 1/2" of the all over snowflake Edge to Edge Holographic Cardstock for the card base. Cut 4 ½”x6” pink Adorable Scorable and glue to the base leaving a 1/4" border of the holographic cardstock. Cut two 10" lengths of pink sequined ribbon. Slip the end of a ribbon through each slit allowing the longest end to go over the die cut acetate. Place Extra Sticky Tape along the 1/4" scored and folded area going over the end of the ribbon and attach to the back of card. 

Die cut all the snowflakes once out of the white reverse side of the pink Adorable Scorable and again out of the holographic cardstock, set aside. Die cut a small from the holographic and the matching scalloped die out of the white reverse side of the pink Adorable Scorable. Foam tape the oval to the scalloped then glue them to the base as shown. Die cut two sentiment "Let it Snow" out of pink and white then glue off set to the center of the ovals. Glue snowflakes all over the front and inside as shown, some overlapping. Place Jewel Dazzles™️ in the snowflake centers and vary sizes.