Penguin Party Pop-Up Card

Instructions:

1. For the card: Cut 8¼"x5” from the left end of the Penguin Party Santa & penguins border cardstock. Place it horizontally and score it 1¼", 2¼", 6", and 7" from the left edge. Crease the inner scores in valley folds and the outer scores in mountain folds. 

2. Cut 4⅝"x1¾" acetate, then score it ½" in from each end. Crease the scores in mountain folds. Place ½" sticky tape on the outer surface of each end tab, then adhere them to the 1" sections of the card, aligning the lower edges and making sure the card folds flat when moving it to the left or right.

3. Place ¼" sticky tape along the bottom edge of the inner Santa die-cut shown. attach it to the acetate, centered inside the card. Cut 6¼"x1" acetate and place ½" sticky tape on each end. Flatten the card one direction and adhere the acetate across the front, aligning the lower edges.

4. Place white border Dazzles™ near the side edges of the card, trimming the excess. Leaving both frames of the Santa die-cut connected, use ¼" sticky tape on the left and right edges to adhere it to the front as shown. Foam tape the “winter wishes” die-cut to the front at the lower right.

5. For the back: Cut 3½"x4¾" Penguin Party polar bear insert paper with the bear in the lower left corner and glue it centered on the card back. Foam tape the “sending Christmas cuddles…” die-cut to the upper right. Place pastel blue border Dazzles™ on each side panel as shown, trimming the excess.