Warm Wishes Holiday Card
For the card front: Turn the card with the fold at the top and cover the front with red cardstock, leaving the right half unglued. Cut 6¼"x4¾" Eggnog tan snowflakes paper and glue centered on the front. Cut 1"x4¾" Eggnog red snowflakes paper and glue 3/8" from the right edge. Punch out the Eggnog die cuts shown and remove the nibs.
Punch a hole in the right end of the red/green label. Cut the ribbon in half, then tie an end of each together. Insert the long ribbon ends through the label from the front and pull until the knot is against the label. Glue the label to the front as shown, then wrap the ribbon ends to the back and glue. Glue the right half of the constructed front to the card base.
Cut out the Eggnog “warm wishes” label, then glue the 1½" snowflake die cut and foam tape the remaining pieces as shown. Place pearls on the deer’s snowflakes and on the small snowflake die cut.
For the inside: Cut 5"x4" Eggnog red/white snowflakes paper and mat on red cardstock with 1/8" borders. Mat on gray cardstock with 1/32" borders, then glue centered on the inside. Cut out the Eggnog “may the spirit…” sentiment, then punch out the die cuts shown and remove the nibs. Mat the sentiment on red cardstock with 1/16" borders. Glue and foam tape the pieces and place pearls as shown.
Punch a hole in the right end of the red/green label. Cut the ribbon in half, then tie an end of each together. Insert the long ribbon ends through the label from the front and pull until the knot is against the label. Glue the label to the front as shown, then wrap the ribbon ends to the back and glue. Glue the right half of the constructed front to the card base.
Cut out the Eggnog “warm wishes” label, then glue the 1½" snowflake die cut and foam tape the remaining pieces as shown. Place pearls on the deer’s snowflakes and on the small snowflake die cut.
For the inside: Cut 5"x4" Eggnog red/white snowflakes paper and mat on red cardstock with 1/8" borders. Mat on gray cardstock with 1/32" borders, then glue centered on the inside. Cut out the Eggnog “may the spirit…” sentiment, then punch out the die cuts shown and remove the nibs. Mat the sentiment on red cardstock with 1/16" borders. Glue and foam tape the pieces and place pearls as shown.