Let It Snow Double Front Card
For the card: Fold a medium blue 8¼"x6" card blank closed, then open it. On the front only, measure 2" in from the left end and mark it. Cut from the lower front edge up to the fold on this mark. Repeat on the right end. Close the card’s three front panels.
For the outer front: Cut 5½"x3" Snowfall acetate and place 2-sided tape on the back along each short edge. Attach the acetate to the two outer front panels 1/8" up from the bottom edge, spanning over the center panel. Cut two 1¾"x5½" Let It Snow gray foiled feathers cardstock and glue one centered on each side panel.
Punch out these acetate snowflakes: a 3", a 1½", a 1", and a ¾" snowflake. Punch out a 2 1/8" and 1½" dark blue cardstock snowflake. Stack the 1½" cardstock and the ¾" acetate snowflake with a tiny piece of foam tape between them. Attach them to the front at the lower right.
Stack the remaining snowflake die-cuts, largest to smallest, with foam tape between them, then attach them to the acetate as shown. Place silver “happy holidays” Dazzles™ on the acetate as shown, then place silver diamond sparkles in the snowflake centers. Open the outer front.
For the inner front: Die cut a large snowflake from white cardstock and cut the straight edge with ½" wide edge. With the straight edge at the top, cut 4¼" from the left end of the snowflake. Use Sticky Specks to attach it to the center front panel, aligning the right edges and placing the upper edge along the fold.
From the remainder of the snowflake die-cut, trim a 3¼"x3¼" lacy section. Use Sticky Specks to attach it to the center panel along the lower and left edges as shown. Place silver border Dazzles™ along the upper and lower edges of the center panel, trimming the excess.
For the outer front: Cut 5½"x3" Snowfall acetate and place 2-sided tape on the back along each short edge. Attach the acetate to the two outer front panels 1/8" up from the bottom edge, spanning over the center panel. Cut two 1¾"x5½" Let It Snow gray foiled feathers cardstock and glue one centered on each side panel.
Punch out these acetate snowflakes: a 3", a 1½", a 1", and a ¾" snowflake. Punch out a 2 1/8" and 1½" dark blue cardstock snowflake. Stack the 1½" cardstock and the ¾" acetate snowflake with a tiny piece of foam tape between them. Attach them to the front at the lower right.
Stack the remaining snowflake die-cuts, largest to smallest, with foam tape between them, then attach them to the acetate as shown. Place silver “happy holidays” Dazzles™ on the acetate as shown, then place silver diamond sparkles in the snowflake centers. Open the outer front.
For the inner front: Die cut a large snowflake from white cardstock and cut the straight edge with ½" wide edge. With the straight edge at the top, cut 4¼" from the left end of the snowflake. Use Sticky Specks to attach it to the center front panel, aligning the right edges and placing the upper edge along the fold.
From the remainder of the snowflake die-cut, trim a 3¼"x3¼" lacy section. Use Sticky Specks to attach it to the center panel along the lower and left edges as shown. Place silver border Dazzles™ along the upper and lower edges of the center panel, trimming the excess.
