Smile! Card
Card front: Place your card with the fold on the top. Use a ruler to mark the top center with a pencil. Mark the bottom center, and then connect the dots. Repeat on the left and right sides to make a cross, dividing the card into 4 sections. Glue Darkroom burgundy tile paper to the upper right section, blue scuffed paper to the lower left, and yellow marble paper to the lower right. Use a craft knife and ruler to cut a 1/4" wide strip of extra copper material from the edge of the Dazzles™ sheet. Place along the top of the card. Do the same along the bottom of the card. Do a third strip, this time 1/2" wide, along the middle of the card.
Cut two complete filmstrips from the filmstrip acetate. You will need to use the middle two frames of each of the strips. Cut just outside the thick black border on the left and right of the middle frames of each of the strips. They should line up on the card, fitting almost exactly. Trim a narrow slice off of each side until they fit perfectly.
Stamp the camera with VersaMark™ the three different patterned papers as shown and dust with Copper Glitter embossing powder. Tap off the excess and set with a heat gun. Mat each on black cardstock with a 1/16" border. Placing the filmstrip acetate over the card for alignment, glue the cameras to the top right, bottom left, and bottom right quadrants. Cut 2 5/8"x2" scrap paper and place it on the card 1/4" from the top and 3/8" from the left. Trace around the rectangle with a pencil. Open the card and carefully cut out the rectangle with a craft knife.
Use strips of Ultra Clear Tape to glue the filmstrip acetate strips centered on the card as shown. Place filmstrip border Dazzles™ vertically along the black bars on the left, right, and center, trimming excess. Place a flash Dazzles&trade,; a small camera Dazzles&trade,; and the word "Smile!" on black cardstock and cut around, leaving a 1/16" border. Glue the flash and the camera to the top left and bottom right of the top left acetate frame, as shown.
Card inside: Cover the inside with Darkroom yellow tile paper. Glue the "Smile!" to the inside so that it is centered diagonally in the cut-out window as shown.
Cut two complete filmstrips from the filmstrip acetate. You will need to use the middle two frames of each of the strips. Cut just outside the thick black border on the left and right of the middle frames of each of the strips. They should line up on the card, fitting almost exactly. Trim a narrow slice off of each side until they fit perfectly.
Stamp the camera with VersaMark™ the three different patterned papers as shown and dust with Copper Glitter embossing powder. Tap off the excess and set with a heat gun. Mat each on black cardstock with a 1/16" border. Placing the filmstrip acetate over the card for alignment, glue the cameras to the top right, bottom left, and bottom right quadrants. Cut 2 5/8"x2" scrap paper and place it on the card 1/4" from the top and 3/8" from the left. Trace around the rectangle with a pencil. Open the card and carefully cut out the rectangle with a craft knife.
Use strips of Ultra Clear Tape to glue the filmstrip acetate strips centered on the card as shown. Place filmstrip border Dazzles™ vertically along the black bars on the left, right, and center, trimming excess. Place a flash Dazzles&trade,; a small camera Dazzles&trade,; and the word "Smile!" on black cardstock and cut around, leaving a 1/16" border. Glue the flash and the camera to the top left and bottom right of the top left acetate frame, as shown.
Card inside: Cover the inside with Darkroom yellow tile paper. Glue the "Smile!" to the inside so that it is centered diagonally in the cut-out window as shown.