Wishes Card
Card front: Place a blank card with the fold on top. Cover with Rosemary & Thyme cream/white tapestry paper. Place a Silver Jewel Border Dazzles™ across the top and bottom, ¼” from the edges. Glue a turquoise dotted ribbon across the card center and trim the edges even with the card.
Die cut the largest scalloped oval from a Turquoise Gemstone Shimmer Sheetz. Place in the Snowflake embossing folder and run through the machine. Sand lightly to make the snowflakes stand out. Foam tape centered on the card front. Zot™ a bow over the ribbon on the left as shown.
Use the large tree cutting dies to cut one of each shape from white Ultra Smooth cardstock. Use the small tree cutting dies to cut two of each shape from white Ultra Smooth cardstock. Use the shaping tools in a circular motion to round out each tree shape and give it dimension.
Begin with the largest bottom tree shape. Hold with a tweezers. Ink the bottom edge with VersaMark™ ink, and dip into the clear embossing powder. Heat until melted and while still hot, dip into the Spoonful of Snow. Heat again, from the bottom of the paper. If it did not leave enough “snow,” heat and dip again into the Spoonful of Snow. Heat again from the back to set. Repeat this procedure for each of the tree layers. Use Zots™ to assemble the tree layers to create one large tree and two small trees. Place foam tape down the center of each tree so it will retain its 3D shape, and place each tree onto the scalloped oval as shown. Color a “Wishes” Dazzles™ with Turquoise Spectrum Noir™ BT7. Place on the bottom right corner.
Card inside: Die cut the largest scalloped oval from Rosemary & Thyme cream/tan tapestry paper. Glue to a 5¼”x4¼” Turquoise Shimmer Sheetz. Glue to the card center. Place the pinecone Dazzles™ as shown. Color the “Winter Greetings” Dazzles™ with BT7 marker. Place as shown.
Reverse Tweezers (optional)
Die cut the largest scalloped oval from a Turquoise Gemstone Shimmer Sheetz. Place in the Snowflake embossing folder and run through the machine. Sand lightly to make the snowflakes stand out. Foam tape centered on the card front. Zot™ a bow over the ribbon on the left as shown.
Use the large tree cutting dies to cut one of each shape from white Ultra Smooth cardstock. Use the small tree cutting dies to cut two of each shape from white Ultra Smooth cardstock. Use the shaping tools in a circular motion to round out each tree shape and give it dimension.
Begin with the largest bottom tree shape. Hold with a tweezers. Ink the bottom edge with VersaMark™ ink, and dip into the clear embossing powder. Heat until melted and while still hot, dip into the Spoonful of Snow. Heat again, from the bottom of the paper. If it did not leave enough “snow,” heat and dip again into the Spoonful of Snow. Heat again from the back to set. Repeat this procedure for each of the tree layers. Use Zots™ to assemble the tree layers to create one large tree and two small trees. Place foam tape down the center of each tree so it will retain its 3D shape, and place each tree onto the scalloped oval as shown. Color a “Wishes” Dazzles™ with Turquoise Spectrum Noir™ BT7. Place on the bottom right corner.
Card inside: Die cut the largest scalloped oval from Rosemary & Thyme cream/tan tapestry paper. Glue to a 5¼”x4¼” Turquoise Shimmer Sheetz. Glue to the card center. Place the pinecone Dazzles™ as shown. Color the “Winter Greetings” Dazzles™ with BT7 marker. Place as shown.
Reverse Tweezers (optional)