Snowfall Window Card
For the card front: Place the card with the fold at the top. From the 12"x12" paper set, cut 6¼"x4¾" Snowfall purple border paper with the border along the bottom. Center it on the card front, but just use the low tack tape on two edges to secure it in place.
Center the 5"x3¼" oval die on the front and secure it with low tack tape. Open the card and die cut the oval window. Remove the snowflake paper and discard the tape. Cut 6"x4" Snowfall acetate and attach it over the window with 2-sided tape along the edges.
Squeeze squiggly lines of Fluffy Stuff over the base of the snowflakes paper and follow the manufacturer’s directions to heat it. Use 2-sided tape to attach the paper to the card front, aligning the window edges.
Remove the Snowfall chipboard deer from the base, then press the Seal Brown ink pad over it to completely ink the front. Let the ink dry for a couple minutes, then lightly spritz water over it. Let the water dry (you should see a mottled effect on the deer). Glue the deer to the front at the lower right as shown.
Cut out the small Snowfall “season’s greetings” cutout and mat it on light blue cardstock with 1/8" borders. Glue it to the upper left, then Decorate the front with small blue snowflake Dazzles™.
For the inside: Cut 6"x4¼" Snowfall purple border paper from the 6"x6" paper set. Squiggle Fluffy Stuff over the snow base on the right half only, then heat to set the “snow.” Mat the side and bottom edges on dark purple cardstock with 1/8" borders, then glue it to the inside with the upper edge against the card fold.
Cut out the small Snowfall “be merry” label and mat it on dark blue cardstock with 1/8" borders. Foam tape it to the inside at the lower right. Remove the chipboard trees from the base and ink the front with Pine Tree. Spritz as before and let the trees dry.
Center the 5"x3¼" oval die on the front and secure it with low tack tape. Open the card and die cut the oval window. Remove the snowflake paper and discard the tape. Cut 6"x4" Snowfall acetate and attach it over the window with 2-sided tape along the edges.
Squeeze squiggly lines of Fluffy Stuff over the base of the snowflakes paper and follow the manufacturer’s directions to heat it. Use 2-sided tape to attach the paper to the card front, aligning the window edges.
Remove the Snowfall chipboard deer from the base, then press the Seal Brown ink pad over it to completely ink the front. Let the ink dry for a couple minutes, then lightly spritz water over it. Let the water dry (you should see a mottled effect on the deer). Glue the deer to the front at the lower right as shown.
Cut out the small Snowfall “season’s greetings” cutout and mat it on light blue cardstock with 1/8" borders. Glue it to the upper left, then Decorate the front with small blue snowflake Dazzles™.
For the inside: Cut 6"x4¼" Snowfall purple border paper from the 6"x6" paper set. Squiggle Fluffy Stuff over the snow base on the right half only, then heat to set the “snow.” Mat the side and bottom edges on dark purple cardstock with 1/8" borders, then glue it to the inside with the upper edge against the card fold.
Cut out the small Snowfall “be merry” label and mat it on dark blue cardstock with 1/8" borders. Foam tape it to the inside at the lower right. Remove the chipboard trees from the base and ink the front with Pine Tree. Spritz as before and let the trees dry.