Joy To All Poinsettia Card
For the card front: Punch out the poinsettia center from the card. Place the card on the craft sheet and rub the Fired Brick ink pad over the front, completely covering it. Let dry, then fold the card following the package directions.
Cut ¾"x4 5/8" Hopscotch striped paper and glue to the front, 1/8" from the left edge. Cut three 4 5/8" Dazzles™ borders, then place one on each side of the strip and one on the strip as shown.
Punch out the largest poinsettia die cut and remove the nibs. Stamp the large and small poinsettia decorations on the die cut with Fired Brick ink. Foam tape it to the front, aligning the poinsettia edges, then place 4mm rhinestones as shown.
For the inside: Cut 4 5/8"x4 5/8" Hopscotch red dotted paper and glue to the inside. Cut ¾"x4 5/8" Hopscotch striped paper and glue next to the fold. Cut two 4 5/8" Dazzles™ borders and place one on each side of the striped paper.
Punch out the center from the medium die cut. Remove the nibs from the medium die cut, then stamp the poinsettia design on it with Fired Brick. Close the card and glue the stamped poinsettia to the inside, positioning it through the opening in the front. Open the card.
Stamp “joy to all” in the poinsettia center opening and the larger snowflake decoration in each outer card corner with Jet Black. Cut three 2¾" Dazzles borders and place near the outer edges as shown. Place a 4mm rhinestone on each corner decoration and smaller rhinestones on the poinsettia petals as shown.
Cut ¾"x4 5/8" Hopscotch striped paper and glue to the front, 1/8" from the left edge. Cut three 4 5/8" Dazzles™ borders, then place one on each side of the strip and one on the strip as shown.
Punch out the largest poinsettia die cut and remove the nibs. Stamp the large and small poinsettia decorations on the die cut with Fired Brick ink. Foam tape it to the front, aligning the poinsettia edges, then place 4mm rhinestones as shown.
For the inside: Cut 4 5/8"x4 5/8" Hopscotch red dotted paper and glue to the inside. Cut ¾"x4 5/8" Hopscotch striped paper and glue next to the fold. Cut two 4 5/8" Dazzles™ borders and place one on each side of the striped paper.
Punch out the center from the medium die cut. Remove the nibs from the medium die cut, then stamp the poinsettia design on it with Fired Brick. Close the card and glue the stamped poinsettia to the inside, positioning it through the opening in the front. Open the card.
Stamp “joy to all” in the poinsettia center opening and the larger snowflake decoration in each outer card corner with Jet Black. Cut three 2¾" Dazzles borders and place near the outer edges as shown. Place a 4mm rhinestone on each corner decoration and smaller rhinestones on the poinsettia petals as shown.
