Reindeer Holiday Rectangle Swing Card
For the papers: Trace or photocopy the paper patterns included in the rectangle swing card package, then cut them out. Trace and cut the left side paper pattern from Eggnog red/white stitching paper and the right side pattern from white/red snowflakes paper. Glue in place. Cut the spine from Eggnog striped paper and glue in place.
Open the card. Beginning at the lower left corner, place Dazzles™ words along the outer edges of the card. Continue around the top and right card edges. For the bottom edge, start again at the lower left corner and continue across the lower edge. Close the card.
For the front: Trace and cut the outside rectangle from Eggnog red paper and glue centered on the swinging rectangle area that shows when the card is closed. Cut out the Eggnog “Greetings” label and mat on cardstock with 1/32" borders. Foam tape the greeting to the rectangle center. Place Dazzles™ in the corners as shown.
Punch out the three Eggnog die cuts shown on the front and remove the nibs. Insert the ribbon in the tag hole, and then use thread to tie the ribbons together just above the tag top. Glue the tag and heart and foam tape the snowflake to the front, and place rhinestones as shown.
For the inside: Cut the inside rectangle from Eggnog red paper and glue centered on the inner swinging rectangle panel. Cut out the sentiment and glue centered on the red paper. Punch out the Eggnog reindeer die cut and remove the nibs. Glue the reindeer and place rhinestones as shown.
Black embroidery thread
Open the card. Beginning at the lower left corner, place Dazzles™ words along the outer edges of the card. Continue around the top and right card edges. For the bottom edge, start again at the lower left corner and continue across the lower edge. Close the card.
For the front: Trace and cut the outside rectangle from Eggnog red paper and glue centered on the swinging rectangle area that shows when the card is closed. Cut out the Eggnog “Greetings” label and mat on cardstock with 1/32" borders. Foam tape the greeting to the rectangle center. Place Dazzles™ in the corners as shown.
Punch out the three Eggnog die cuts shown on the front and remove the nibs. Insert the ribbon in the tag hole, and then use thread to tie the ribbons together just above the tag top. Glue the tag and heart and foam tape the snowflake to the front, and place rhinestones as shown.
For the inside: Cut the inside rectangle from Eggnog red paper and glue centered on the inner swinging rectangle panel. Cut out the sentiment and glue centered on the red paper. Punch out the Eggnog reindeer die cut and remove the nibs. Glue the reindeer and place rhinestones as shown.
Black embroidery thread