Love Is Where You Are
Photo: Mat 4”x6” Photo with black cardstock, leaving 1/8” border. Mat with Sunshine & Shadows yellow paper, leaving 5/8” border and ink edges black. Mat with black cardstock, leaving 1/8” border and glue 1 ¾” from the top and 3 1/8” from the right edge.
Background: Tear the top edge of Sunshine & Shadows gray dot paper to 12”x3 3/8” and ink torn edge. Tear the top edge of black cardstock and use as mat for gray dot paper, leaving ¼” border at the bottom and ½” border at the top. Glue across the Sunshine & Shadows black/yellow paper, ½” from the bottom.
Using permanent ink, stamp the Fresh Cut large flower stamp 4 times on Yellow Moire Holographic Plastic Sheet. Cut out the flowers and heat edges with heat gun, curling them slightly. Fill the center of each blossom with dots of black glitter glue and let dry. Stamp 8 leaf sprigs onto Lime Moire Holographic Plastic Sheet. Cut out leaves and heat ends to curve slightly. Place 2 layers of foam tape behind the glittered center of each blossom. Place 1 at the top right photo corner and 3 along the border as shown.
Zot the leaves to extend from under the blossoms. Use ¾” wide black crepe Sunshine & Shadows ribbon to make a bow with 3” and 6” tails. Zot the bow below the left side of the flowers and Zot the tails among the leaves as shown. Write or print on thin strips of white cardstock and ink edges black. Glue below the flower border and above the single flower as shown.
Background: Tear the top edge of Sunshine & Shadows gray dot paper to 12”x3 3/8” and ink torn edge. Tear the top edge of black cardstock and use as mat for gray dot paper, leaving ¼” border at the bottom and ½” border at the top. Glue across the Sunshine & Shadows black/yellow paper, ½” from the bottom.
Using permanent ink, stamp the Fresh Cut large flower stamp 4 times on Yellow Moire Holographic Plastic Sheet. Cut out the flowers and heat edges with heat gun, curling them slightly. Fill the center of each blossom with dots of black glitter glue and let dry. Stamp 8 leaf sprigs onto Lime Moire Holographic Plastic Sheet. Cut out leaves and heat ends to curve slightly. Place 2 layers of foam tape behind the glittered center of each blossom. Place 1 at the top right photo corner and 3 along the border as shown.
Zot the leaves to extend from under the blossoms. Use ¾” wide black crepe Sunshine & Shadows ribbon to make a bow with 3” and 6” tails. Zot the bow below the left side of the flowers and Zot the tails among the leaves as shown. Write or print on thin strips of white cardstock and ink edges black. Glue below the flower border and above the single flower as shown.