Vintage Roses Twist-Easel Thankful Card
For the card: Cut the card to 5"x5", then open it and place it horizontally, inside down. Score the front from the upper right corner down to the center fold. Crease the score in a mountain fold, then unfold it, and close the card, and place it with the center fold on the left.
For the front: Cut 4¾"x4¾" Vintage Roses chicken wire paper and cut it in half diagonally from the upper right to the lower left corners. Glue a triangle paper centered on each triangular front panel. Place a silver border Dazzles™ across the top edge of the upper triangle paper, trimming the excess.
Remove the chipboard flowers shown from the base. Press each onto the embossing ink pad to completely coat it with ink. Cover each with the Iron Age embossing powder, tap off the excess, and heat the remainder to melt it. Emboss two chipboard butterflies with Copper Tinsel powder.
Glue the lower stems of the flowers to the lower front triangle panel so they “grow” from ½"-1" from the lower edge, upward and above the angled fold. (When you fold on the score line, the flower tops should extend up above the fold.) Glue the butterflies as shown.
Trim the Vintage Roses “thankful” cutout to 3 1/8"x1", then mat it on cardstock with 1/8" borders. Place the remainder of the same silver border Dazzles™ on the label below the greeting, trimming the excess. Foam tape the label’s lower edge and glue the upper edge, placing it over the stem ends.
For the inside: Cut 4 5/8"x4 5/8" Vintage Roses border paper with the roses along the lower edge. Place silver border Dazzles™ along the upper and right edges, trimming the excess. Mat the paper on cardstock with 1/8" borders and glue it to the inside center.
For the front: Cut 4¾"x4¾" Vintage Roses chicken wire paper and cut it in half diagonally from the upper right to the lower left corners. Glue a triangle paper centered on each triangular front panel. Place a silver border Dazzles™ across the top edge of the upper triangle paper, trimming the excess.
Remove the chipboard flowers shown from the base. Press each onto the embossing ink pad to completely coat it with ink. Cover each with the Iron Age embossing powder, tap off the excess, and heat the remainder to melt it. Emboss two chipboard butterflies with Copper Tinsel powder.
Glue the lower stems of the flowers to the lower front triangle panel so they “grow” from ½"-1" from the lower edge, upward and above the angled fold. (When you fold on the score line, the flower tops should extend up above the fold.) Glue the butterflies as shown.
Trim the Vintage Roses “thankful” cutout to 3 1/8"x1", then mat it on cardstock with 1/8" borders. Place the remainder of the same silver border Dazzles™ on the label below the greeting, trimming the excess. Foam tape the label’s lower edge and glue the upper edge, placing it over the stem ends.
For the inside: Cut 4 5/8"x4 5/8" Vintage Roses border paper with the roses along the lower edge. Place silver border Dazzles™ along the upper and right edges, trimming the excess. Mat the paper on cardstock with 1/8" borders and glue it to the inside center.
