Butterfly Wishes Card
Card front: Place a blank card with the fold on your left and cover with Mirage teal/yellow tile paper. Place Border Dazzles™ 1/16” from the right and left sides, trimming even with the top and bottom edges of your card.
Follow your die-cutting machine manufacturer's instructions to cut several butterfly outlines of different sizes from 5 ½”x7” scrap cardstock. Using the cardstock as a stencil, place it over your card on the craft sheet and tape in place.
Follow the Perfect Airbrush manufacturer's instructions to remove the inner pen barrel. Remove the cap from the chisel point end of Spectrum Noir pen #BT7 and insert into the airbrush pen barrel (see instructions for correct placement). Hold over the stencil and spray generously through the die-cut openings (do not saturate). Remove the Stencil. Place pen #BP6 in the airbrush and lightly spray along the sides of your card.
Zot™ on a length of white dotted sheer 1” from the bottom, gluing the ends under the paper edges. Tie lengths of teal and yellow glimmer ribbon on the left. Place “Make a WISH” Dazzles™ on the upper right, as shown.
Cut one large, one medium and three small butterflies from acetate and place on the craft sheet. Spray the bodies and outer wings edges with pen #BP6 and the remaining areas with #BT7. Turn each butterfly over and bend up the wings. Zot™ onto the card as shown, saving a small butterfly for the inside.
Card inside: Cut a “v” in the left ends of 3”x3/4” and 2”x1/2” Mirage teal/yellow tile papers. Glue even with the right side 1/8” apart, and 1” from the top edge of your card. Place Border Dazzles™ 1/16” from the right side, trimming even with the top and bottom edges of your card. Lightly spray the right card edge with pen #BP6. Zot™ on the remaining butterfly, as shown.
Follow your die-cutting machine manufacturer's instructions to cut several butterfly outlines of different sizes from 5 ½”x7” scrap cardstock. Using the cardstock as a stencil, place it over your card on the craft sheet and tape in place.
Follow the Perfect Airbrush manufacturer's instructions to remove the inner pen barrel. Remove the cap from the chisel point end of Spectrum Noir pen #BT7 and insert into the airbrush pen barrel (see instructions for correct placement). Hold over the stencil and spray generously through the die-cut openings (do not saturate). Remove the Stencil. Place pen #BP6 in the airbrush and lightly spray along the sides of your card.
Zot™ on a length of white dotted sheer 1” from the bottom, gluing the ends under the paper edges. Tie lengths of teal and yellow glimmer ribbon on the left. Place “Make a WISH” Dazzles™ on the upper right, as shown.
Cut one large, one medium and three small butterflies from acetate and place on the craft sheet. Spray the bodies and outer wings edges with pen #BP6 and the remaining areas with #BT7. Turn each butterfly over and bend up the wings. Zot™ onto the card as shown, saving a small butterfly for the inside.
Card inside: Cut a “v” in the left ends of 3”x3/4” and 2”x1/2” Mirage teal/yellow tile papers. Glue even with the right side 1/8” apart, and 1” from the top edge of your card. Place Border Dazzles™ 1/16” from the right side, trimming even with the top and bottom edges of your card. Lightly spray the right card edge with pen #BP6. Zot™ on the remaining butterfly, as shown.