Truck Card

Follow the instructions on the package to die cut the Bendi card. Die cut the base arch out of the brown Autumn Garden 12x12 solid cardstock. Die cut the crane image from the Brilliant Backgrounds paper pad using the third die in on the Nested Arches die set. Glue to the brown base leaving a 1/8" brown border above it and flush to the bottom. Be sure to go over the die-cut slit again with the retractable knife. 

Split the two largest yellow trucks from the "Ready to Rumble" decoupage set. Split the layers into two sets and assemble with foam tape. These will be applied to the Bendi layers.

Die cut the center layer out of dark orange Solid cardstock. Die cut the rock area of the same paper pad page and remove 1/8" off the bottom leaving a 1/8" orange border and secure with mono adhesive. The slit should still match up but go over it again with the retractable blade. Secure the largest truck to the top of this layer with extra sticky tape along only the bottom of the truck base. Avoid the slit when placing the truck. Secure to the back of the base layer with extra sticky tape.

Die cut the front layer out of light orange Solid cardstock. Die cut bricks of the same paper pad page using the same front layer die from the Bendi card set. Trim off the bottom so there is a 1/8" light orange border and it is flush to the left side. Glue to the light orange layer. Secure the truck flush to left side with extra sticky tape as shown. Place gold studs to the right as shown. Foam tape the "Have an Awesome Day" sentiment at the top of the base layer.